Example Design Checklist
____ Completed submittal application provided____ Plans are clear and legible
____ A minimum of two and a maximum of three sets of plans and calculations provided
____ Plans are signed and dated by the RME (each sheet)
____ Calculations are signed and dated by the RME
____ North arrow provided
____ Common scale provided on the plans
____ Each room use is identified on the plans
____ Specification sheets for all devices (horns, smoke detectors, heat detectors, panels’ etc.)
provided
____ Voltage drop calculations provided
____ Battery drop calculations and discharge curves provided
____ Specifications for wiring (gauge etc.) provided
____ Information on type of conduit to be used provided
____ Riser diagrams provided
____ Wiring from device to device and end of line resistor provided on the plans
____ Total feet of wiring provided on the plans
____ Total feet of wiring provided from device to device
____ Legend for all devices provided on the plans
____ Device address numbers/letters provide on the plans for addressable or analog systems
____ Type of power, primary secondary etc. provided on the plans
____ Total number of each device to be installed provided on the plans (horns 22, heats 12
etc.)
____ Materials utilized in the specification booklet indicated by an arrow to identify the model
or part
____ Cross section(s) provided on the plans
